EN
Sippy Bottle
Dr. Brown’s® Milestones™ soft silicone sippy spout and sippy bottle are designed to help your child
transition from bottle to cup. The sippy spout can also be used in place of the nipple/teat on
Dr. Brown’s® Options+™ Bottles when the internal vent system has been removed. Sippy spout
will not work properly with the vent system installed, or in non-Dr. Brown’s Options+ Bottles.
Read and save these instructions for future use.
BEFORE FIRST AND EACH USE
Before rst use, fully disassemble all parts, wash the product, then place the components in boiling water
for ve minutes. This is to ensure hygiene. To prevent a possible choking hazard, pull on the spout in all
directions before each use to ensure it does not tear. Inspect carefully, especially when the child develops
teeth. Discontinue use and replace the spout immediately if any signs of wear or damage are visible, such as
cracking or change of shape. Small pieces can accidentally be inhaled and cause serious injury.
CLEANING
Fully disassemble all parts and wash prior to each use. The spout must be clean and free of obstructions.
All parts are safe for use in dishwasher (top rack only), electric sterilizer, microwave sterilizer, or boiling water.
SIPPY BOTTLE ASSEMBLY
Insert sippy spout from bottom side of collar and pull spout from top until it snaps into place. Fill bottle for
feeding and tighten collar with spout onto bottle. If your sippy bottle has Dr. Brown’s Silicone Handles,
place bottle on a rm surface. Start the handles at the top and apply downward pressure to both handles
at the same time. Adjust the handles until they are at the desired height. To remove, place bottle in soapy
water and carefully slide the handles o. When transporting bottles, always keep them upright with cap on
to help prevent leaking.
For your child’s safety and health
WARNING!
• Continuous and prolonged sucking of uids will cause tooth decay.
• Always check food temperature before feeding.
• Throw away at the rst signs of damage or weakness.
• Keep components not in use out of the reach of children.
• Never attach to cords, ribbons, laces, or loose parts of clothing. The child can be strangled.
• Never use sippy spout as a pacier/soother.
• Always use this product with adult supervision.
• Always check the spout for signs of wear and replace when damaged.
• Do not use a microwave oven to heat the bottle as microwave ovens can create hotspots in
milk/formula and/or bottle components.
• Do not leave the spout in direct sunlight, heat, or in sterilizing solution for longer than recommended
as this may weaken the spout.
• Do not allow a child to walk or run while using any bottle.
• Do not let a child take a bottle to bed or self-feed for long periods.
To Next Page
Need help?
General
