Dr.coffee F11 Series - Disassemble Flowmeter; Disassemble Water Inlet Valve

REV1.0
Dr.coffee Service Manual 40
9.2.4 Disassemble flowmeter
Step：First unplug the wiring plug on the flowmeter, then pull up the flowmeter (can be picked up with a screwdriver as shown in Figure 3), and
finally unplug the connected water pipe to take out the flowmeter and disassemble the flowmeter.
★ Attention：
1、Be careful during the disassembly process to prevent scratching your fingers！
2、There may be residual water in the pipe. Please prepare the water container in advance！
9.2.5 Disassemble water inlet valve
Step：First pull out the water guide cover (can be picked up with a screwdriver), then pull up the water guide and unplug the connected water pipe.
Disassemble the water inlet valve
★ Attention：
1、Be careful during the disassembly process to prevent scratching your fingers！
2、There may be residual water in the pipe. Please prepare the water container in advance！
1
2
3
4
1
2
3
4
Technicup Service Manual