Dr.coffee F11 Series - Disassemble Grinder Group

REV1.0
Dr.coffee Service Manual 41
9.2.6 Disassemble grinder group
Step1：(Figure 1) First remove the bean holder, then (as shown in Figure 2) press the buckle marked with the red circle to
remove the Hall sensor group, and then unplug the wiring plug on the power board.
Step2：(As shown in Figure 1, 2) Grab the parts of the grinder by hand, take out the whole grinder group upwards, and disassemble
the grinder group.
★ Attention：
1、Be careful during the disassembly process to prevent scratching your fingers！
2、Before removing the grinder group, please empty the residual coffee beans and coffee powder in the grinder！
1
2
3
1
2
3
Technicup Service Manual