Dr.coffee F11 Series - Disassemble Control Board; 9.2.10 Disassemble Power PCB

REV1.0
Dr.coffee Service Manual 44
9.2.9 Disassemble control board
Step：(Figure 1) First unplug all the wiring plugs on the main control board, then (as shown in Figure 2) remove the four screws that fix the main
control board, and finally remove the main control board.
★ Attention：
1、Unplug the coffee machine before doing this！
2、When pulling the cable plug, please press the buckle first and then pull the plug to prevent the terminal from being broken！
9.2.10 Disassemble power PCB
Step：(Figure 1) First unplug all the power plugs on the power board, then (as shown in Figure 2) remove the five screws that secure the power board,
and finally remove the power board.
★ Attention：
1、Unplug the coffee machine before doing this！
2、When pulling the cable plug, please press the buckle first and then pull the plug to prevent the terminal from being broken！
1
2
3
1
2
3
Technicup Service Manual