Dr.coffee F11 Series - 9.2.15 Disassemble Pressure Regulating Valve

REV1.0
Dr.coffee Service Manual 49
9.2.15 Disassemble pressure regulating valve
Step1：First (as shown in Figure 1), in the direction of the arrow, hold the gear lever bracket and pull up the gear lever
set.
Step2：Hold the slag bar as shown in Figure 1 and gently rotate the hook position counterclockwise to release the hook and
push the slag bar upward.
Step3：Use a flat-blade screwdriver to press (as shown in Figures 1-4) the buckle at the position indicated by the arrow,
loosen all the buckles, and remove the top cover of the brewer.
Step4：(Figure 1, 2) Hold the stepper motor holder by hand, rotate the counterclockwise direction, then pull up the accumulator
valve group, and remove the accumulator valve group.
★ Attention：
1、Unplug the coffee machine before doing this！
1
blade screwdriver to press (as shown in Figures 1
2
3
1
(Figure 1, 2) Hold the stepper motor holder by hand, rotate the counterclockwise direction, then pull up the accumulator
(Figure 1, 2) Hold the stepper motor holder by hand, rotate the counterclockwise direction, then pull up the accumulator
2
(Figure 1, 2) Hold the stepper motor holder by hand, rotate the counterclockwise direction, then pull up the accumulator
3
(Figure 1, 2) Hold the stepper motor holder by hand, rotate the counterclockwise direction, then pull up the accumulator
4
(Figure 1, 2) Hold the stepper motor holder by hand, rotate the counterclockwise direction, then pull up the accumulator
5
★
1
2
3
2
3
1
Technicup Service Manual