Dräger Alcotest 9510 - Page 28

28 Dräger Alcotest 9510 Washington Technical Manual V3.1 2014
Troubleshooting Table
34
INHALATION
DETECTED
Negative br
eath
hose flow was
detected w
hen the
instrument is not
expecting any flow
or negative breath
flow (inhalation) was
detected during
Please Blow mode.
Status code is for information only.
Ensur
e blowing does not occur
unless PLEASE BLOW appears on
the display. Ensure subject is
blowing into breath hose during
PLEASE BLOW instead of
inhaling.
36
CALIBRATION
EXPIRED - OUT
OF SERVICE
X
Contact WSP technician
37
R
TC PROBLEM
X
General error
message for Real
Time Clock
har
dware errors
Contact WSP technician
38
HARDWARE
ERROR
X
General indicator for
har
dware related
error
messages
Contact WSP technician
39
INTERNAL
STANDARD
ERROR
X
The results of the
intern
al standard
measurement wer
e
outside of the
tolerance limits.
Contact WSP technician
41
DATA INPUT
TIMEO
UT
Data entry activity
wa
s not completed
within the allowable
time.
Perfor
m another test and complete
the data e
ntry section without
leaving the instrument idle for more
than 10 minutes at a time.
42
BATTERY
VO
LTAGE
ERROR
X
The DC power
supply drops below
10.5V
.
Depending on the voltage level,
this error may not be possible.
Contact WSP technician.
43
FLASH DELAY
ERROR
X
A potential problem
was observed
during
the write
cycle of EEPROM
Contact WSP technician
45 DATALOGGING
ERROR
X
A problem was
obser
ved while
sending or stor
ing
information to the
database
Contact WSP technician
46 REFUSAL X
Subject Refusal Status code is for information only
based on operat
or assessment that
subject refu
sed to provide breath
samples. No instrument remedy
required. Follow WSP procedures
for handling subject refusals.