EasyManua.ls Logo

Dräger Atlan A350 - Page 14

Dräger Atlan A350
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14 Supplement | Atlan A300, A350 ceiling-mounted versions and wall-mounted version
Ceiling-mounted version with service cart
Accessories
If an accessory is fitted to the device which projects below the lowest point of the
anesthesia workstation, the accessory may strike objects or persons when the
ceiling supply unit is lowered. Personal injury or property damage may result as a
consequence.
Only fit accessories that maintain a distance of at least 12 cm (4.7 in) from the
floor when the anesthesia workstation is lowered to its lowest point.
Load
The product labels attached to the shelves and the drawer indicate the permissible
maximum load.
If the maximum total weight of the ceiling supply unit is exceeded, the load cannot
be supported. Personal injury or property damage may result as a consequence.
Refer to the instructions for use of the ceiling supply unit and observe the
maximum total weight.
In addition to the nominal weight and any other accessories (such as carrying
systems or monitors), these loads must be considered when calculating the total
weight.
Transport for service activities
There is an increased risk of tipping over once the device has been connected to
the service cart.
Preparation for transport and actual transport of the device on the service cart
may be carried out only if there is no patient in the immediate vicinity.
When the device is connected to the service cart, it must not be used as the
trolley version.
For transport, move all the fitted arms into the transport position. To do this,
swing the arms toward the center of the device and secure them with a strap.
This transport position is required for inclines greater than 5°.
Take particular care when moving the device, as it can tip over under certain
circumstances.

Other manuals for Dräger Atlan A350

Related product manuals