Dräger Evita 2 Dura - Ventilation Controls

Operating Concept
10
Ventilation Controls
Operating Concept
Ventilation Controls
1 Keys for selecting the ventilation modes:
– IPPV
– SIMV
– BIPAP
and
– other modes
2 Keys for selecting/setting ventilation parameters:
– Tidal volume V
T
– Inspiration time Tinsp
– Frequency f
– Inspiratory flow Flow
– Inspiratory pressure P
insp
– Pressure-assisted spontaneous breathing ΔPASB
– Positive end-expiratory pressure PEEP
– Pressure rise time Ramp
– O
2 concentration O2
– Sensitivity Trigger
3 Central "turn-and-push" rotary knob for setting the
parameters:
To set = turn the rotary knob
To confirm setting = press the rotary knob.
Setting ventilation parameters
2 To set a ventilation parameter = press the corresponding
parameter key. The yellow LED in the key lights up.
3 To set the value of the ventilation parameter = turn the rotary
knob. The value is displayed next to the parameter key.
3 To confirm the value = press the rotary knob. The yellow
LED goes out.
Selecting the ventilation mode
1 Hold down the appropriate key for about 3 seconds
or
press the appropriate key briefly and confirm = press the
rotary knob.
The selected ventilation mode will now be activated.
For detailed instructions on setting the ventilation modes,
see page 41.
001
D
3
1
2
Evita 2 dura