Preparing for use
22
For ventilating adults and children
1 Hang the hinged arm from the rail on the left-hand side and
tighten screws.
● Connect ventilation hoses, and note length of hose
(metres).
2 Turn ports in direction of hoses.
3 Install water traps in vertical position at the lowest point of
their hose lines.
● Connect the Y-piece, with the rubber sleeve of the Y-piece
on the inspiratory side.
Fitting the temperature sensor (option)
4 Push the sensor as far as it will go into the rubber sleeve on
the inspiratory side of the Y-piece. Align the Y-piece so that
the sensor is on top.
5 Attach the sensor cable with hose clips.
6 Insert the probe of the temperature sensor into the socket
»Temp.
« at the rear of the unit.
Do not place any containers with liquid on or above the
ventilator! Any leaking or spilled liquid can cause
malfunctions!
059
0.6m
0.4m
0.6m
0.4m
0.6m
1
3
2
060
4
5
061
6
m
To Next Page
Loading...
