Dräger Evita 2 Dura - Performing the Device Check; Preparing the Child Test Lung 84 09 742

31
Preparing for use
Device Check
Preparing the child test lung 84 09 742
for the paediatric hose set
The test lung consists of a tracheal tube CH 12 to simulate the
resistance of the airways and a small bellows to simulate
compliance.
● Only insert the elbow connector into the Y-piece when
Evita 2 dura advises you to do so on the screen.
Performing the device check
● Switch on the machine = raise flap* and press power switch
on the back panel until it clicks into position.
Evita 2 dura runs through its self-test procedure.
● Wait until the 10-second test phase has been completed.
After the self-test:
1 Switch Evita 2 dura to standby = Hold down key »O« for
about 3 seconds.
2 Switch off the standby alarm tone with the »Alarm Reset«
key.
● Touch the »Device check« menu key.
The standby alarm tone cannot be switched off with
the »
g« key.
* Mains power switch flaps may differ, depending on the power
supply used, see "Switching on", page 38.
074017075
D
Evita 2 dura
2
1