Transfer of Data
TRANSFER FROM DRÄGER MONITOR TO
DRÄGER MONITOR
Step 1 - Press Menu key.
Step 2 - Place Dräger Monitor in Standby.
Step 3 - Go to destination monitor and press the Menu.
Step 4 - Click on Admit/Discharge.
Step 5 - Click Transfer (If you are transferring data form
outside the destination care unit, go to Step 6.
Otherwise go to Step 8).
Step 6 - Click on Select Care Unit to transfer from. A
list of care units appears. If you are monitoring
only one care unit, this item is ghosted.
Step 7 - Click on the care unit from which you are
transferring data. The selected unit appears next
to Care Unit.
Step 8 - Click on Select Bed to transfer from to display
beds currently in standby.
Step 9 - Click on the source bed to display it on the menu.
Step 10 - Click on Start Transfer to this bed.
Step 11 - Click on Transfer to this bed to transfer patient
data and display the banner Transfer In Progress,
or on Cancel to return to the previous menu.
Step 12 - Press the Main Screen fixed key on the source
monitor to exit Standby mode.
Infinity Delta/Delta XL/Kappa - Quick Reference Guide
Intended for quick reference only.
Refer to Instruction For Use Manual.
INFINITY DELTA/DELTA XL/KAPPA - QUICK REFERENCE GUIDE | 14
© 2010 Draeger Medical, Inc.
To Next Page
Loading...
