28-22 DELTA/DELTA XL/KAPPA VF8
28 P
ERIPHERAL DEVICES AND ASSOCIATED SOFTWARE
The Surgical Display - Display Options Submenu
Click on one of the following settings to configure the indicated functions:
Pressure
Overlap
When ON, the first set of adjacent
invasive pressure waveforms (up to
four, counting from the top) are
overlapped in single channel. The
bottom line is a common zero point.
The top line is the upper limit of
whatever scale was configured for
each overlapped waveform.
Parameter names and their assigned
scales are listed across the top of the
overlap channel.
•ON
•OFF
1 Sec. Time
Lines
Displays vertical markers at 1-s
intervals in waveform channels
•ON
•OFF
Pressure
Grids
Determines setting for the pressure
grids displayed in the invasive
pressure channels.
•None
• 25%
• 50%
Video
Resolution
Determines quality of the video
display
•High
•Medium
•Low
Sweep Speed Determines waveform sweep speed •Slow
•Normal
•Fast
Parameter
Display
Moves parameter boxes to right or
left of the waveform display
•RIGHT
•LEFT
The Elapsed Time Key
Elapsed Time Displays or removes up to two timers
in bottom left corner of ISD screen
NOTE: Click on timer to reset after
displayed.
Click on one of the following settings:
•Begin Timer A
•Begin Timer B
• Remove Timer A
• Remove Timer B
The Surgical Display - Save/Restore Submenu
This submenu allows you to configure the following functions.
Restore Setup Restores setup highlighted in
second menu column
Click on the setting of your choice.
Save Setup Saves setup highlighted in second
menu column
Click on the setting of your choice.
Rename
Setups
Accesses data entry screen Name and rename ISD setups using the
procedures described in chapter 2,
Monitor Setup (page 2-5).
Last Saved/
Restored
Displays most recently saved or
restored ISD setup
Not applicable
New Setup Displays current ISD setup Not applicable
Menu
Selection
Description Settings
To Next Page
Loading...
