Dräger MQG 02 0 Series - 5.1 Error

18 Technical manual | X-am
®
2800 / X-am
®
5800
Troubleshooting
5.1 Error
The sensor technology that can be used depends on the device type.
The first digit of the code represents the sensor channel:
Code Sensor channel Code Sensor channel
2xx DrägerSensor CatEx SR 6xx EC4
3xx EC1 7xx IR
4xx EC2 8xx IR
5xx EC3 9xx PID
Code Cause Remedy
102 Customer’s period of use counter
has expired.
Reset period of use counter with
Dräger CC-Vision.
103 Gas detector defective. Contact DrägerService.
104 Program code checksum error Contact DrägerService.
105 Bump test interval expired Carry out bump test.
108 Gas detector defective. Contact DrägerService.
109 Menu function cannot be per-
formed as an error has occurred.
Determine fault code using the
Info menu and disable if neces-
sary.
110 Alarm element test faulty. Repeat the alarm element test
with X-dock.
111 Faulty alarm element test:
Alarm LED
Repeat the alarm element test
with X-dock.
112 Faulty alarm element test:
Horn
Repeat the alarm element test
with X-dock.
113 Faulty alarm element test:
Vibration motor
Repeat the alarm element test
with X-dock.
115 Gas detector disabled by X-dock. Activate device with X-dock.
118 X-am pump flow alarm Check gas circuit for leaks.
119 Hardware error (pump) Contact DrägerService.
120 X-am pump battery main alarm Charge pump.
121 Battery main alarm Charge the gas detector.
122 Internal device error Switch the gas detector off and on
again.
Contact DrägerService.
123 Hardware error
(reference voltage source)
Contact DrägerService.
124 Device temperature too high. Operate gas detector within per-
mitted temperature range.
125 Device temperature too low. Operate gas detector within per-
mitted temperature range.
126 Gas detector defective. Contact DrägerService.