Dräger MQG 02 0 Series - 6.14 Cleaning; 7 Configuration; 7.1 Standard gas configuration for X-am 2800

42 Technical manual | X-am
®
2800 / X-am
®
5800
Configuration
6.14 Cleaning
The gas detector does not require any special care.
If it is heavily soiled, wash off the gas detector with cold water, using a sponge if
necessary. Dry the gas detector with a cloth.
NOTICE
Damage to the gas detector!
Harsh cleaning utensils (e.g. brushes), detergents and solvents can destroy the
dust and water filters.
► Only clean the gas detector with cold water and, where necessary, a sponge.
7 Configuration
After a change to the configuration (e.g. with the CC-Vision PC software), check
the basic functions of the gas detector (e.g. alarm elements).
7.1 Standard gas configuration for X-am 2800
Different settings can be selected to meet customer requirements on delivery. The
current setting can be checked and changed with the Dräger CC-Vision PC
software.
The Dräger CC-Vision PC software can be downloaded at
www.draeger.com/software.
For information on suitable cleaning agents and disinfectants and their
specifications, see document 9100081 at
www.draeger.com/IFU.
DrägerSensor
Measuring
range
Alarm A1
- threshold
acknowledgeable latching
Alarm A2
- thresh-
old
acknowledgeable latching
CatEx SR [%LEL]
0 to 100 20
-
40
-
XXS O
2 [Vol%]
1)
1) There are 4 alarm thresholds for O2 2 ↑ (increasing) and 2 ↓ (decreasing).
0 to 25
↓19.5 | ↑22.
5
- ↓19 | ↑23 -
XXS O
2 PR [Vol%]
1) 2)
0 to 30
↓19.5 | ↑22.
5
- ↓19 | ↑23 -
XXS CO LC [ppm]
0 to 2000 30 - 60 -
XXS H
2S LC [ppm]
0 to 200 5 - 10 -
XXS NO
2 [ppm]
0 to 50 5 - 10 -
XXS SO
2 [ppm]
0 to 100 0.5 - 1 -