Technical manual | X-am
®
2800 / X-am
®
5800 45
Device settings
Procedure:
1. Plug the DIRA dongle mount with the dongle into the socket for the calibration
adapter.
2. Insert the switched-on gas detector into the calibration adapter and press it
down until it locks into place.
3. Connect the DIRA USB cable to the PC.
7.3.1.2 Configuring the gas detector with the Dräger CC-Vision PC software and
reading the data memory
Requirements:
– The gas detector is connected to the PC.
To configure the gas detector using the Dräger CC-Vision PC program, refer to the
Dräger CC-Vision online help.
With the Dräger CC-Vision PC software, the data logger can be downloaded as a
JSON file.
7.3.1.3 Reading the data memory with Dräger GasVision
Requirements:
– The gas detector is connected to the PC.
The data memory is read ans visually represented with the Dräger GasVision PC
software (refer to the Dräger GasVision online help).
An interface is available for the infrared communication when reading out the
measured values in external devices. Contact Dräger for more information
concerning the use of this interface.
8 Device settings
Only trained and qualified personnel may change the device settings.
8.1 Factory settings
Different settings can be selected to meet customer requirements when ordering.
The setting can be checked and changed with the Dräger CC-Vision PC software.
Device settings via CC-Vision:
The changed parameter settings must be checked after being transferred to the
gas detector to ensure that the values have been transferred correctly.
Parameters that cannot be viewed on the gas detector must be read out and
checked after being changed using the Dräger CC-Vision PC software.
Device settings via a cloud solution:
In order to guarantee compliance with EN 50271, the transmitted parameters
must be verified when configuration settings are changed.
To Next Page
Loading...
