DIAGNOSTICS (continued) NM2C
2.2 Service Log
The Service Log Screen displays a tabular listing of each service event
including date, time, parameter, code and event description as shown in Figure
2-4.
To enter the Service Log screen from the Main Service Screen, highlight
SERVICE LOG (ref. Figure 2-3) with the selection wheel and press the trigger.
With SCROLL LOG highlighted, press the trigger to enable scrolling through
the list of service log entries with the selection wheel.
To obtain a printout of the service log (if you are in the Scroll mode, first
return to the selection mode by pressing the trigger), select PRINT LOG and
press the trigger to activate the printer.
Select EXIT and press the trigger to return the display to the Main Service
Screen.
SERVICE LOG
DATE TIME PARAMETER CODE DESCRIPTION
11-01-92 10:26 XXXXXXXX XXXX INSTALLATION
11-01-92 10:30 XXXXXXXX XXXX SOFTWARE STARTUP
11-02-92 07:30 XXXXXXXX XXXX O2 CAL
11-13-92 09:44 XXXXXXXX XXXX SOFTWARE STARTUP
SELECTS
FUNCTION
⇒ ACTIVATES
FUNCTION
EXIT
PRINT LOG
SCROLL LOG
Figure 2-4: SERVICE LOG
Rev. A
2-4
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
To Next Page
Loading...
