SOFTWARE UPDATE PROCEDURE (continued) NM2C
FIGURE 7-2: NARKOMED 2C LOAD MODE SCREEN
NARKOMED 2C BOOT
SYSTEM STARTUP
COPYRIGHT (C) 1994, NAD INC.
VERSION: X.XX
SOFTWARE ID: XXXX
NM2C SOFTWARE LOADER
LOADING IMAGE
VERSION X.XX NM2C SW
7.3 INSTALLING NM2C SOFTWARE FROM THE ORDM
To install NM2C software from an ORDM, a 3½ in. floppy disk with the Narkomed
2C software is needed.
7.3.1 Insert the floppy disk into the ORDM.
7.3.2 Set the System Power switch on the Narkomed 2C to STANDBY.
7.3.3 Press and hold the SILENCE and AUTOSET keys on the remote display,
and turn the System Power switch to ON. Release the keys when the load
mode screen shown in Figure 7-2 appears.
Software installation is complete when the machine resets.
Rev. G
7-4
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
To Next Page
Loading...
