SOFTWARE UPDATE PROCEDURE (continued) NM2C
7.5 INSTALLING NM2C SOFTWARE FROM THE ORDM USING THE SST
In order to run the SST from an ORDM, a 3½ in. floppy disk with Narkomed
2C SST software is needed.
7.5.1 Insert the NM2C SST disk into the ORDM floppy disk drive.
-- Turn the System Power switch to STANDBY, then return the switch to
ON.
-- Wait for several minutes until the remote display screen displays the SST
Main menu (Figure 7-3).
7.5.2 Select ENTER PRIMARY SERVICE from the SST main menu.
7.5.3 Select Load System Software from the Primary Service menu (Figure 7-8);
The software load screen shown in Figure 7-9 appears.
7.5.4 Select the desired protocols, and press ESC on the ORDM keyboard; follow
the on-screen instructions to download the software.
Software installation is complete when the machine resets.
Rev. G
7-6
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
To Next Page
Loading...
