Getting Started
42
Instructions for Use Oxylog 2000 plus SW 1.n
Check connections
1 Ensure that the gas supply has been
connected.
2 Ensure that the test lung has been connected.
The Oxylog 2000 plus automatically checks if a test
lung has been connected. The device check is
aborted if a test lung is not detected within one
minute.
The check is continued when the test lung is
detected.
3 Ensure that the configured hose system has
been connected, either
– the disposable hose system
or
– the reusable hose system.
4 Confirm the appropriate hose system. The sec-
ond page of the device check appears.
If the wrong hose system has been configured:
1 Press the Alarm Reset key to cancel the device
check.
2 Select the correct hose system. Refer to "Select
hose type" on page 74.
3 Restart the device check.
System check
1 Set the controls (A) below the display to the
required values.
The Oxylog 2000 plus successively activates the
audible and visual alarm signals and prompts the
operator to acknowledge each signal.
2 Confirm the audible and visual alarm signals.
The device check continues automatically.
During the automatic test sequence, the Oxylog
2000 plus checks the flow, pressure levels and
alarm signals. Corresponding sounds are heard.
The bar graph shows the progress made by the
check.
The result is displayed on the Oxylog 2000 plus.
3 Confirm. The system returns to the menu
screen.
A monthly check of the power failure alarm is
recommended.
1 Disconnect the external power supply.
2 Remove the battery to activate the audible
alarm signal.
3 Listen for the audible alarm.
4 When the power failure alarm test is completed,
reinstall the battery into the battery compart-
ment of the Oxylog 2000 plus.
023
NOTE:
Contact DrägerService if no alarm is heard.
Oxylog 2000 plus
A
To Next Page
Loading...
