26 Pocket Guide Oxylog 3000 plus
Operation
Setting pressure support PC-BIPAP/PS
The following can also be set on the display for
PC-BIPAP:
– Setting on page 1: Pressure support
Δ
Psupp above
PEEP.
– Setting on page 2: Pressure rise time Slope.
Flat slope = long pressure rise time
Medium slope = medium pressure rise time
Steep slope = short pressure rise time.
SpnCPAP, SpnCPAP/PS
Spontaneous Continuous Positive Airway Pressure
Set the ventilation pattern with the controls below the
display:
– Maximum airway pressure Pmax.
–O
2 concentration FiO2.
The following can be set on the display:
– Positive end expiratory pressure PEEP.
– Pressure support
Δ
Psupp above PEEP.
– NIV - Non-invasive ventilation.
– Insp.term.%PIF
Inspiration termination criterion of pressure suppor-
ted strokes, as percentage of the peak inspiratory
flow (PIF).
– Hose type
The selected hose type must match the hose type in
use. Otherwise a correct volume measurement can-
not be guaranteed.
– Cuvette type (optional)
If
Δ
Psupp is set above 0 mbar, the following can also be
set on the display for SpnCPAP:
– Sensitivity Trigger.
Successful patient triggering is indicated by an aste-
risk (*) on the left side of the curves window.
– Pressure rise time Slope (effective for pressure
support
Δ
Psupp).
12437171
15737171
To Next Page
Loading...
