Dräger Oxylog VE300 - Device Configuration; General Configuration Parameters

74 Instructions for use | Oxylog VE300 SW 1.n
Configuration
9 Configuration
9.1 Setting configuration parameters
To access the configuration dialog:
Standby mode
1. To move to screen 2 of the dialog, touch the button 1 in the top right-hand corner
of the screen.
2. Touch the button System setup (A).
Operation mode
1. To access the screen where the ventilation mode can be selected, touch the
X button in the top right-hand corner of the ventilation dialog.
Alternatively: Press the start dialog key on the control panel.
2. To move to screen 2 of the dialog, press button 1 in the top right-hand corner of
the screen.
3. Touch the button System setup (A).
In the configuration dialog the following information can be displayed and changed:
– Screen brightness (B)
– 25 %, 50 %, 75 %, 100 %
– Breathing circuit (C)
– Disposable, Reusable
– HME (D)
– On, Off
– Ventilation (volume) (E) (option)
– VC-CMV, VC-SIMV
– CO
2 cuvette (F) (option)
– Disposable, Reusable
2858228683
A
BC D
E
F
G
H