Instructions for use | Oxylog VE300 SW 1.n 81
Configuration
To change the password:
1. Touch the Change password button.
2. Enter the new four-digit code. Touch the relevant buttons, set the new digits, and
confirm.
3. After entering all of the digits, touch the Next button.
4. Enter the password again.
On the last dialog page the change of the password is confirmed with the
Password changed. message. If both entries of the new password were not
identical, the Password not changed. error message is displayed.
9.9.7 Device settings
Here the system settings with which the device starts up can be specified.
The device settings are spread across two dialog pages:
On dialog page 1/2 the following device settings can be displayed and changed:
– Breathing circuit (A)
– Disposable, Reusable
– HME (B)
– On, Off
– Pressure unit (C)
– cmH
2O, mbar
– CO
2 cuvette (D)
– Disposable, Reusable
– Gas supply (E)
– 100 % O
2, 93 % O2
– CO2 unit (F)
– mmHg, Vol%, kPa
3306033061
To Next Page
Loading...
