Dräger X-am 1100 - Battery Pre-Alarm; Battery Main Alarm; Device Alarm; End of Operation

19
Identifying Alarms
Battery pre-alarm
Acknowledging the pre-alarm:
● Press the key. Only the audible alarm and the vibration alarm are switched off.
— The battery still lasts approx. 20 minutes after the first battery pre-alarm.
Battery main alarm
The battery main alarm cannot be acknowledged or cancelled:
— The device is automatically switched off again after 10 seconds.
Device alarm
— The device or one or several sensor channels are not ready for operation.
— For remedies, refer to page 22 to page 24.
● If necessary, commission the Dräger Safety Service Center to eliminate the error.
End of operation
Only in the case of X-am 1100 and X-am 1700.
A warning period starts before the end of the operating time.
— After switching on the device, the special symbol » « (for warning) is displayed.
Acknowledging the end of operation warning:
● Press the key. The device will continue to operate until the operating time has elapsed.
— When the operating time has elapsed, the text » d 0 « flashes. The device cannot be
switched on anymore.
The alarm is indicated by an intermittent alarm message:
Flashing special symbol » « on the right side of the display:
The alarm is indicated by an intermittent alarm message:
Flashing special symbol » « on the right side of the display:
Intermittent alarm message:
Special symbol » « on the right side of the display:
OK
on
OK
on