Dräger X-AM 5000 - Configuring the Device

26
Configuring the Device
Configuring the Device
To individually configure a device with standard configuration, the device must be
connected with a PC.
The installed PC software Dräger CC Vision is used for configuration.
 Observe the documentation and online help of the software.
 A version of Dräger CC-Vision which can be used for Dräger X-am 5000
can be
downloaded from the following web address: www.draeger.com
/software.
IR
Calibration cradle (order no. 83 18 752)
with inserted
USB DIRA with USB cable (order no. 83 17 409)
USB DIRA with USB cable
(order no. 83 17 409)
E-Cal module Dräger X-am 125
(order no. 83 18 754)
USB 2.0
USB 2.0
USB 2.0 / COM
01423999_01_en.eps
Dräger
CC-Vision
Dräger
CC-Vision
Dräger
CC-Vision
E-Cal
0
0
0
X-am 5000