Dragon Touch K10 - Optional Connections; Connecting to a Computer

11 12
OPTIONAL CONNECTIONS
SPECIFICATIONS
Connecting to a Computer
Connect the tablet to a computer to transfer files.
1. Connect your tablet to the computer.
With the included USB cable: Plug the small end of the cable into the USB 2.0 high speed
connector of the tablet. Plug the large end of the cable into an available USB 2.0 high
speed port on the computer.
2. When your tablet is connected, slide down the USB icon then touch icon USB
connected.
3. Mount the storage.
Tap button Transfer files (MTP) to mount the tablet’s built-in storage. When it is mounted,
you can copy files to or from your tablet.
Processor
RAM
Storage
Display
Wi-Fi Networking
Audio Output
PC Interface
Additional Features
Operating System
Power
Playback Time
(hours)
MTK8163 (Quad-core ARM Cortex-A53 64-bit up to 1.3GHz)
2GB DDR3
16 GB flash built-in; Micro SD card slot (max.128GB supported)
10.1'' 800*1280, Capacitive touchscreen
IEEE 802.1 1 a/b/g/n
3.5mm headphone
USB 2.0 high speed
Up to 6 hours music, 4 hours video, 4 hours web browsing
Built-in microphone 2X1W speaker
Front facing camera 2.0MP Rear camera 2.0MP
Android 8.1
Rechargeable Li-poly battery Power Adapter (USB 5V, 2A)
Bluetooth 4.0
TROUBLESHOOTING
1. Device doesn’t power on.
• Reboot your device after charging it for 30 minutes.
• Shortly press your power button to check if it lights up in case your device is in sleep
mode.
• Press the power button for 20 seconds.
• Start a hard reset by pressing the reset button with a pin if there is reset button on your
actual device.