IMPORTANT INFORMATION ON THE RIGGING:
• Always check the rigging, halyards, reefing lines, water stays, rudder downhaul and
Swing Wing system before taking the boat out to sea.
• Every 6 months or minimum once a year shorten the main halyard and reefing lines
approx. 25 cm. if needed. After some years, you can turn them around or replace the
lines.
• For the Touring and Sport version, we recommend changing the water stays after max
10 years and/or by max 15.000 NM of sailing. Use only same products and quality
when changing. The water stays are made in 10 mm Dyeform quality.
• For the Performance version, we recommend changing the water stays after max 7
years and/or by max 10,000 NM of sailing – use only same products and quality when
changing. The water stays are made in 10 mm Dyeform quality.
• Side stays and forestay must be changed after max 10 years and or by max 15.000
NM.
• Standing spreader rigging on the mast must be changed after max 15 years.
• Never use shackles or similar on the boats man chair .
• NEVER climb the rigging when the boat is in folded position.
• Tension on the rigging, please see rig diagram.
• Never change the tension on the spreader diamonds without checking tension with a
tension meter according to rig tension diagram, changing the rig tension can cause
the mast to break.
• Never drill holes in the carbon mast section without asking your dealer or Quorning
Boats beforehand.
• Never wrap the mast in any plastic, as this can cause the paint to bubble up. If
wrapping is needed, use only breathable textile materials.
• If rigging and diamonds are taken apart for the winter, mark all parts and the exact
position of the turnbuckles so exact same tension can be set again.
• By releasing tension on the diamond cables, this will affect the stiffness/safety of the
mast and can cause the mast to collapse, so don´t the tension.
To Next Page
Loading...
