- 3 -
GENERAL SAFETY INSTRUCTIONS
FOR AIR TOOL PRODUCTS
WARNING
Please read the following instructions carefully, failure to do so could lead to serious
personal injury.
IMPORTANT
Draper Tools Limited recommends that this machine should not be modified or used for
any application other than that for which it was designed. If you are unsure of its relative
applications do not hesitate to contact us in writing and we will advise you.
1. Always wear safety goggles or glasses.
2. Always ensure machine is switched off before connecting to air supply.
3. Disconnect any machine form the air supply before changing blades or discs and
before servicing any type of machine.
4. Always keep your air tool clean and lubricated. Daily lubrication is essential to avoid
internal corrosion and possible failure.
5. Do not wear watches, rings, bracelets or loose clothing when using air tools.
6. Using only light weight coil hoses from a tool to the wall or compressor coupling . Do
not fit quick change couplings onto the machine as vibration can cause the coupling
to fail.
7. Do not overload the machine. Allow the tool to operate at it optimum speed for
maximum efficiency.
8. Do not increase the air pressure above the manufacturers recommended level, as
excessive overload can cause the machine casing to split. Also this creates excessive
wear on moving part and may cause possible failure.
9. In the interests of safety and possible damage to the machine/operator, always ensure
the machine has stopped before putting it down after use.
10. Always ensure the work piece is is firmly secures leaving both hands free to control
the machine.
11. Always ensure that accessories such as blades, discs, sockets, etc. are
rated/designed for use with the machine and are securely fastened correctly before
connecting the machine to the air supply.
12.When grinding, sanding or cutting always wear appropriate face mask or
respiratory equipment.
To Next Page
Loading...