Speed
Control Throttle
Brake
Accelerate
Connecting
1. Turn on the board.
2. Press the board power button for 5seconds.lt will flash.
3. Turn on the remote, then press the pair button. the signal indicator will flash and the power button light will
flash with the same frequency. Then means the paired successfully.
4. Push the joystick, forward to test the accelerate, and backward to test the brake. After testing all functions
work normally you can start your riding.
Acceleration/DecelerationButtons
The speed at which the skateboard accelerates/decel-
erates depends on how far down you push the Throttle.
Please start with the low speed mode to be familiar with
the accelerate and brake of the skateboard.
8
To Next Page
Loading...