DRESKAR FT001 - Drive Belt Replacement Frequency; Cleaning Bearings and Wheels

● Regularly inspecting your board for damage and checking that it is run
ning properly.
● Before riding make sure all screws are tight.
● Do not clean the board with harsh abrasives or chemicals; using a
semi-damp cloth to wipe off dust and dirt from belts, bearings and
wheels.
● Turn off the board and remote controller when not in use.
● Keep your board battery fully charged when not in use.
● Recharge the battery every 3 month.
● Do not leave the board charging unattended
● Disconnect the battery from charger once it is fully charged.
● Do not modify the electrical controls or wiring.
Howoftenshouldyoureplacedrivebelts?
Generally, whether to replace the belt depends on the frequency of your use and the
degree of wear and tear of the belt. It is suggested that you should check the belt once a
week. If the belt wears severely, the belt needs to be replaced.
Generally, the drive belt needs to be replaced after 6 months of use.
HowtocleanthebearingsandWheels
It is important to clean your electric skateboard after each ride. Clean the electric skate-
board with a slightly damp cloth and prevent any water or dirt from entering the electronic
components. After this, wipe the board with a dry cloth.
To maintain your bearings. You can do this with the special maintenance oil "Bearing
Cleaner & Lube". This oil is specially developed for the maintenance of the bearings and
ensures that your bearings last a long time.
17