– 10 – – 11 –
child’s bedroom where the alarm is being used. If the alarm triggers then it is
working correctly and is not being affected by electromagnetic interference.
The issue will be how the Urosensor
™
is being placed or your child is not
waking to the sound of the alarm. See section on My child sleeps through
the alarm.
2.
Read instructions 3 & 4 of the section on How to use your DRI Sleeper
®
eclipse, or experiment with other methods of locating the Urosensor
™
in the
section on Other ways to position the Urosensor
™
in underwear.
i. Always make sure the Urosensor
™
has been dried completely between
the sensing strips after it has been triggered to ensure that it will reset to
trigger again. If it is not dried completely it will not reset.
ii. Always make sure that the alarm is turned back on after a bedwetting
event if the Urosensor
™
is being used again.
3. If the alarm does not trigger when it is tested in your child’s bedroom there
may be a source of electromagnetic interference, e.g. a night light, baby
monitor or i-pod docking station. Test the alarm in another room in the
house which does not have any wireless electronic devices. If the alarm
triggers successfully try removing all potential sources of electromagnetic
interference in your child’s room.
RADIO FREQUNCY DEVICE
DRI Sleeper
®
eclipse Alarm uses a radio frequency signal which complies with
the requirements of the Radio and Telecommunications Terminal Equipment
(R&TTE) regulations Directive 1999/5/EC dated 9 March 1999.
Electromagnetic elds from non-complying equipment in the home can
sometimes be strong enough to interfere with the DRI Sleeper
®
eclipse function
even though the alarm includes features to protect it from most electromagnetic
interference. Examples of potential sources of electromagnetic interference
include night lights, baby monitors, cordless phones, dimmable lights, i-pod
docking stations, remote controlled door chimes and doors.
BATTERIES
Batteries are provided free of charge and come included with the DRI
Sleeper
®
eclipse alarm. The battery in the alarm unit is a CR2354 coin battery.
Replacement batteries should be available at local electronic and photographic
To Next Page
Loading...
