– 2 – – 3 –
Cleaning the DRI Sleeper
®
eclipse Alarm
Alarm Base: Wipe clean with a damp cloth and some mild detergent or skin
disinfectant. NEVER immerse the alarm base in water or locate it where urine
can enter it.
Urosensor
™
: Rinse in liquid soap and water and dry well especially between the
two black sensing strips.
Note: do not use chlorine-based detergents or cleaners or put the Urosensor
™
in
the washing machine or dryer as this will irreparably damage the sensing strips.
How to use your DRI Sleeper
®
eclipse
1.
Place the alarm on a bedside table near your child’s bed. Switch the
DRI Sleeper
®
eclipse on by moving the ON/OFF switch from position
0 (off) to position 1 (on). The alarm will beep quickly 5 times indicating
it is ready.
2.
Remove the Urosensor
™
from the alarm cradle. Please note that if you
touch the black sensing strips with damp ngers the alarm might trigger.
Therefore, it is best to avoid touching the sensing strips when handling the
Urosensor
™
. If the Urosensor
™
is accidentally triggered in this way switch
off the alarm and dry the Urosensor
™
which resets it, then switch the alarm
back on.
3.
Place the Urosensor
™
with the black sensing strips facing your child’s
crotch inside a minipad which has been prepared by making a pocket in the
absorbent layers of the material. To do this cut a 25mm (1 inch) slit into the
absorbent layers with a pair of sharp scissors. With the point of the scissors
create a pocket for the Urosensor
™
to slide into.
Note: the top layer of a minipad is designed to stay dry and if the Urosensor
™
is
placed just under the top layer it may not become wet and trigger the alarm when
your child wets. Make sure the Urosensor
™
is inserted under some layers of absorbent
material so that they will become wet and press
onto the two black sensing strips on top of the
Urosensor
™
. The two black sensing strips must
be wet to trigger the alarm.
panty liner with Urosensor™
inserted inside hand-cut slit
To Next Page
Loading...
