– 4 – – 5 –
Using double-gusset underpants
1. Cut a 25mm (1 inch) slit through one layer
only of a pair of double-gusset underpants,
down towards the crotch area. The cut can
be made on the inside or the outside of the
underwear.
2. Insert the Urosensor
™
inside the slit with the
black sensing strips facing the crotch.
Note: wrapping the Urosensor
™
in a paper handkerchief or tissue before
inserting it into the slit in the gusset can also help bedwetting to be detected more
quickly.
Using two pairs of underpants
1. Put on two pairs of close tting underpants.
2. Insert the Urosensor
™
in between both pairs
of underpants above the crotch area. Make
sure the black sensing strips are facing the
crotch.
Note: wrapping the Urosensor
™
in a paper
handkerchief or tissue before inserting it between
the underpants can also help the bedwetting to be detected more quickly.
Using a disposable diaper
1. With a sharp pair of scissors cut a 25mm
(1 inch) slit in the absorbent layers on the
inside of the pull-up diaper near the crotch
area.
2. With the point of the scissors create a pocket
for the Urosensor
™
to slide into.
3. Insert the Urosensor
™
inside the pocket with
the black sensing strips facing the crotch.
Note: As with the minipad, it is important that the Urosensor
™
is inserted under
some absorbent layers. However, disposable diapers tend to be highly absorbent
so wrapping the Urosensor
™
in a paper handkerchief or tissue, and inserting it
with the sensing strips facing the crotch area between the body and the diaper
Eclipse wireless bedwetting alarm Urosensor™
Eclipse wireless bedwetting alarm Urosensor™
To Next Page
Loading...
