– 6 – – 7 –
2. The alarm base will start to beep slowly at one second intervals as it ‘listens’
for the Urosensor
™
. Immediately activate the Urosensor
™
by putting
something metal across the sensing strips so that it is sending a signal to the
alarm base. When the alarm base detects the new Urosensor
™
it will beep
rapidly ve times. This means the Urosensor
™
is now paired to the alarm base.
3. If the alarm does not detect the new Urosensor
™
it will continue to beep
slowly for approximately 75 seconds and then will sound one long beep
indicating that it has not been able to detect the device. It is then necessary to
repeat the pairing process.
Note: Only one Urosensor
™
can be used at a time with an alarm. A single alarm
base cannot detect multiple sensors. Whichever Urosensor
™
is last paired with
the alarm, only that Urosensor
™
will trigger the alarm. However, multiple alarm
bases can be used with one Urosensor
™
.
Troubleshooting
My child wets the bed and the Urosensor
™
does not trigger the alarm.
Test that the alarm and Urosensor
™
are working correctly by following these
steps:
1. Switch the alarm on. It should beep rapidly ve times.
2. Wrap the Urosensor
™
in half a 2-3 ply paper handkerchief or some toilet
tissue. Stand 2-3 metres (yards) away from the alarm with your back to it and
drip ½-1 teaspoon of warm water on the Urosensor
™
. It should trigger within
2-3 seconds.
Note: Be careful not to touch the black sensing strips with your ngers as damp
skin can trigger the alarm.
3. If the alarm triggers then it is working correctly. The issue will be how the
Urosensor
™
is being placed.
4. Read instructions 3 & 4 of the section on How to use your DRI Sleeper
®
eclipse, or experiment with other methods of locating the Urosensor
™
in the
section on Other ways to position the Urosensor
™
in underwear.
5. Always make sure the Urosensor
™
has been dried completely between the
sensing strips after it has triggered the alarm to ensure that it will reset and
be able to trigger the alarm again. If it is not dried completely it will not reset
and won’t be able to trigger the alarm if your child wets the bed.
6. Always make sure that the alarm is turned back on after a bedwetting event
if the Urosensor
™
is being used again.
To Next Page
Loading...