NOTE: Wrapping the Urosensor
™
in a paper handkerchief or tissue before
inserting it into the slit in the gusset can also help bedwetting to be detected more
quickly.
Using two pairs of underpants
1. Put on two pairs of close tting underpants.
2. Insert the Urosensor
™
™ in between both pairs of
underpants above the crotch area, near where the
urine will rst escape.
NOTE: Wrapping the Urosensor
™
in a paper
handkerchief or tissue before inserting it between
the underpants can also help the bedwetting to be
detected more quickly.
Using a disposable diaper or pull-ups
1. With a sharp pair of scissors, cut a 25mm
(1 inch) slit in the absorbent layers on the inside
of the pull-up diaper near the area where the urine
will rst escape.
2. With the point of the scissors, create a pocket for
the Urosensor
™
to slide into.
3. Insert the Urosensor
™
inside the pocket.
NOTE: Make sure the Urosensor
™
does not slide
down towards the back of the diaper or pull-ups away from the initial wetting
area.
NOTE: As with the minipad, it is important the Urosensor
™
is inserted under
some absorbent layers. However, disposable diapers tend to be highly absorbent
so wrapping the Urosensor
™
in a paper handkerchief or tissue, and inserting it
between the body and the diaper can help the moisture reach the Urosensor
™
before it is absorbed by the diaper. Diapers that include an absorbent gel layer
should be avoided as these will not result in sufcient moisture getting to the
Urosensor
™
to enable it to trigger.
To Next Page
Loading...