44
This product was designed and manufactured to meet strict quality and safety standards. There are, however, some
installation and operational precautions of which you should be particularly aware.
Please read these instructions before operating Drobo, DroboPro, or DroboShare and save them for future reference.
1. Read all instructions: All safety & operating instructions should be read and understood before operation.
2. Retain instructions: The safety and operating instructions should be retained for future reference.
3. Heed Warnings: All warnings on the appliance and in the operating instructions should be followed.
4. Follow Instructions: All operating and usage instructions should be followed.
5. Drobo, DroboPro, and DroboShare are to be used with UL Listed ITE Equipment only.
6. Avoid Water and Moisture: Drobo, DroboPro, and DroboShare should not be used near water (for example, near a
bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool).
7. Provide Adequate Ventilation: Drobo, DroboPro, and DroboShare should each be situated so that its location or
position does not interfere with its proper ventilation. For example, Drobo should not be situated against a surface
that may block the ventilation openings or placed in a built-in installation such as a bookcase or cabinet that may
impede the flow of air through the ventilation openings. Additionally, no other device other than a Drobo should be
placed on top of DroboShare.
8. Protect from Heat: Drobo, DroboPro, and DroboShare should be situated away from heat sources such as radiators,
heat registers, stoves, or other appliances (including amplifiers) that produce heat.
9. Protect Power Cords: Power supply cords should be routed so that they are not likely to be walked on or pinched by
items placed upon or against them, paying particular attention to cords and plugs, convenience receptacles, and the
point at which they exit from the product.
10. Avoid Object and Liquid Entry: Never push objects of any kind into Drobo, DroboPro, and DroboShare ventilation slots
except drives compliant with the User Guide as they may touch dangerous voltage points or short the parts, resulting
in the risk of fire or electric shock. Never spill liquid of any kind onto Drobo.
11. TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF ELECTRICAL PLUG TO WIDE SLOT AND INSERT FULLY.
12. DROBO AND DROBOPRO CONTAINS A LITHIUM BATTERY WHICH CAN EXPLODE IF MISHANDLED. BATTERY IS NOT FIELD
OR USER-SERVICEABLE. Please dispose of battery in a manner consistent with local jurisdictions.
13. DRIVES IN DROBO AND DROBOPRO WILL RETAIN HEAT AFTER USE. PLEASE USE CAUTION WHEN REMOVING DRIVES
FROM DROBO OR DROBOPRO. TO SAFELY REMOVE DRIVES, PRESS THE DRIVE LATCH TO RELEASE THE DRIVE AND
ALLOW THE DRIVE TO COOL IN THE DATA BAY FOR 10 MINUTES BEFORE COMPLETELY REMOVING THE DRIVE FROM
DROBO OR DROBOPRO. FAILURE TO FOLLOW THIS PROCEDURE MAY RESULT IN INJURY FROM HOT DRIVES.
14. Damage Requiring Service: Drobo, DroboPro, and DroboShare should be serviced by an employee of Data Robotics,
Inc. or a Data Robotics, Inc. Authorized Reseller ("qualified service personnel"), and should be serviced when:
A. THE POWER SUPPLY CORD OR PLUG IS DAMAGED OR FRAYED;
B. LIQUID HAS SPILLED INTO DROBO, DROBOPRO, OR DROBOSHARE;
C. DROBO, DROBOPRO, OR DROBOSHARE HAS BEEN EXPOSED TO RAIN OR WATER;
D. DROBO, DROBOPRO, OR DROBOSHARE DOES NOT OPERATE NORMALLY WHEN YOU FOLLOW THE OPERATING
INSTRUCTIONS;
E. DROBO, DROBOPRO, OR DROBOSHARE HAS BEEN DROPPED OR THE CHASSIS DAMAGED;
F. DROBO, DROBOPRO, OR DROBOSHARE EXHIBITS A DISTINCT CHANGE IN PERFORMANCE.
15. Use only the supplied USB 2.0, FireWire 800, Ethernet, and power cables when operating Drobo, DroboPro, or
DroboShare.
Servicing – The user should not attempt to service Drobo, DroboPro, or DroboShare beyond that described as user service
items in the FAQ section of this manual, the Troubleshooting sections of the Help Files, or the support Knowledge Base. All
other servicing should be referred to qualified service personnel.
Cleaning – Unplug Drobo, DroboPro, or DroboShare from the wall outlet before cleaning. Do not use liquid or aerosol
cleaners; use a damp cloth. If Drobo, DroboPro, or DroboShare comes in contact with any liquid, unplug the power
adaptor and let Drobo dry thoroughly before plugging back in.
Power Source – Drobo, DroboPro, or DroboShare should be operated only from the type of power source indicated on the
marking label or in this User Guide. If you are not sure of the type of power supplied to your home or business, consult
your local power company.
Overloaded Power Outlets – Do not overload wall outlets and extension cords, this can result in risk of fire or electric
shock.
Electric Shock – To reduce the risk of electric shock, do not disassemble Drobo, DroboPro, or DroboShare. Doing so will
void the warranty. Take it to a quailed service person when service or repair work is required. Opening or removing covers
may expose you to dangerous voltage or other risks. Incorrect reassembly can cause electric shock when Drobo or
DroboShare is used.
Moving – Avoid moving Drobo, DroboPro, or DroboShare while it is plugged in to avoid shock and vibration damage to the
installed hard disk drives.
To Next Page
Loading...
