4
Calibrating the QuadAir EXTREME by remote
control
• Step 1: Turn on the remote controller; •
Step
2: Turn on your Drone by holding the power
button located on the top side of the drone.
• Step 3: Place the drone on a horizontal
surface.
• Step 4: Bind the transmitter with the drone
by pushing the throttle (left joystick) up to
the highest position, and then pulling it
straight down to lowest position . Solid
light will indicate successful bind.
• Final Step: Move both sticks to lowest right
corner (like in the image above). LED lights
will start to flash rapidly. Wait a few seconds
till the lights are solid again and you are
done.