Dry Flush Laveo DF1045 - Internal Mechanism Components

6
To the right is the view of the inside of the
Laveo. This view shows the floor panel located
below the Octagon Container.
The Square Key is connected to the shaft of the
gear box (not shown), and is the part
responsible for turning the Octagon Container
during the flush cycle. The Octagon Container
sits on top of the Square Key, and when the
Octagon Container is properly aligned, the
square hole in the container will drop down on
top of the key. You can tell that the Octagon
Container is sitting correctly on the Square Key
by giving the Octagon Container a gentle turn
in the clockwise direction. You should hear the
gear motor making a whirring noise as you
rotate the container, and there should be a
reasonable amount of resistance as you apply a
little force to turn the container.
The Lazy Susan helps to support the Octagon
container, and to assist in the turning of the
container during the twist cycle.