Need help?Do you have a question about the DS18 PRO-CFX and is the answer not in the manual?
General| THD | < 0.01 % |
|---|---|
| Output Impedance | 100 Ω |
| Frequency Response | 20 Hz - 20 kHz |
| Crossover Slope | 12 dB/octave |
| Input Connectors | XLR |
| Output Connectors | XLR |
Specifies the type of passive crossover, indicating it supports High and Low frequencies.
Defines the crossover frequency point at 3.5KHz for 4 OHMS impedance.
Indicates the maximum power handling capability, up to 300 Watts.
Specifies the slope of the crossover filter, set at 12 dB/octave.
Details the available attenuation levels for the tweeter: -3 dB and -6 dB.
States that the top cover is made of Steel.
Identifies the bottom cover material as Clear Acrylic.
Specifies the type of capacitor used in the crossover, which is NP Mylar.
Identifies the type of coil used, which is KSV.
Describes the terminal type for connections as Screw-On.
Details the housing construction: metallic, plastic side covers, and clear acrylic.
Indicates that the primary adjustment available is for Tweeter Attenuation.
Provides the total length of the crossover unit as 6.3 inches or 160 mm.
States the total depth of the crossover unit is 3.5 inches or 88 mm.
Gives the total height of the crossover unit as 1.5 inches or 38 mm.
Lists and describes the function of each terminal for Tweeter and Woofer connections.
Details input signal connections and power supply requirements including REM and +12V.
To Next Page