BEFORE YOU BEGIN
Have the following ready before installation:
Control panel backup battery
Battery connection harness
Batteries for WT5500 2-way wireless keypad
Screwdriver
Prior to installing a GS2065 and TL265GS, contact your monitoring station to determine if it is a master reseller or
visit www.connect24.com and become an authorized dealer. In both instances, you will acquire a Profile Number,
Installer ID Number and an Installer Password.
PLEASE NOTE: You need to activate the SIM card and initialize the communicator 24 HOURS BEFORE
INSTALLATION (Steps 1).
Summary of Installation Steps
Step 1 – Initialize an account via Connect 24 Website (www.connect24.com)
Step 2 – Install and wire the communicator to the control panel (on-site)
Step 3 – Load the programming and test for best signal strength location
Step 4 – Program communication options on the control panel via keypad
Step 5 – Test communicator
To Next Page
Loading...