DSC Power 864 - Page 24

Section 5: Customizing Your System
This section describes how to customize your system to your needs. Refer to this section for
detailed instructions on: programming access codes, setting the time and date, and adjust¬
ing the keypad sounders and lights.
Programming The master code (code 40) can be used to program system options, arm and disarm the sys-
Access Codes tern and program other access codes. You can program up to 32 additional access codes
(01 through 32). You can change or program access codes at both PC55XXZ and LCD key¬
pads. Other access codes, such as system supervisory and duress codes, are available. Con¬
tact your installer for more information.
NOTE: To program duress codes, contact your installer. It is the installer's duty to
program unique numerical combinations for duress codes.
LCD5500Z Keypads
1. Press (*) to enter the function list.
2. Use the C<][>5 keys to scroll to "Press (*) for <> Access Codes".
3. Press (*). The keypad will display "(*) to Edit User Code 01P".
4. Scroll to the code you want to program using the C<][E^ keys. If there is a letter "P"
beside the code number (e.g., [01P]), that code has already been programmed. If there
is no "P", then no code is programmed for that access code number. If an access code
already exists for the code number you select, it will be replaced by the new code.
5. To select a code for editing, press (*). The keypad will display "Enter New Code < >".
6. Enter the new [code]. All codes must be four digits unless otherwise indicated by your
installer. Enter digits 0 through 9 only. Once the code has been entered, the keypad will
beep 3 times. NOTE: Do not use the factory default or obvious codes such as [1111] or
[1234], The keypad will display "(*) to Edit User Code 01P".
7. To exit access code programming, press ©.
8. Record your new codes on the 'System Information' page (p.25) in this booklet.
PC55XXZ and LCD5501Z Keypads
1. Press (g)Q [Master Code], The Program indicator flashes.
2. Enter the two-digit number of the access code you want to program (01-32 for access
codes, 40 for master code). If an access code already exists for the code number you
have selected, it will be replaced by the new code.
3. Enter the new [code]. Access codes must be four digits unless otherwise indicated by
your installer. Enter digits 0 through 9 only. NOTE: Do not use the factory default or
obvious codes such as [1111] or [1234],
4. To exit access code programming, press ®.
5. Record your new codes on the "System Information" page in this booklet.
Erasing a code:
1. Press ® ® [Master Code]
2. Enter the number of the code you want to erase [01 to 32], The Master code cannot be
3. To erase the code, press (*).
4. To exit access code programming, press (*).