Directors: L.A Schmidt, Dave Mac Vay, Grant Schmidt
Total memory erasure:
1. Press and hold the “learn” push button. After 5 seconds the green RX LED will switch on.
Continue holding for another 5 seconds until all the LED‟s start flashing, then release the “learn”
push button. All the LED‟s will flash together 5 times indicating total erasure of receiver memory.
General Indications:
a) A self test procedure is performed when the receiver power supply is connected. Successful
initialization is indicated by 1 short flash of both LED’s. 5 short flashes will indicate that the receiver’s
memory is totally erased.
b) Rapid flashing of the red LED while adding a new transmitter key indicates that the receivers memory
is full (31 keys stored). If this 32
nd
key is saved, the user must be aware that the 1
st
key saved will be
discarded. Additional new keys saved will discard older keys on a “first in / first out” cyclic basis.
c) Rapid flashing of the green RX LED when the remote transmitter push button is pressed indicates that
the remote transmitter battery is low.
Note:
The indications and operation of the DTS RX3 Three channel version receiver is the same as above.
To Previous Page
Loading...
General