Need help?Do you have a question about the Dual CV 1600 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Total Harmonic Distortion | 0.1 % |
| Type | Stereo Amplifier |
| Speaker load impedance | 4 ohms |
| Cooling | Heatsink |
Protects output stages using current limiters and thermal protection.
Connects turntables, tuners, tape recorders and microphones.
Protects output stages using current limiters and thermal protection.
Connects turntables, tuners, tape recorders and microphones.
Explains making tape recordings from various sources.
Explains direct tape-to-tape transfer.
Records from one source while playing another.
Allows direct comparison of recording with the original.
Explains headphone connection and operation.
Explains how to operate the amplifier.
Explains headphone connection and usage.
Basic steps for operating the amplifier after connections.
Controls volume and applies loudness compensation.
Adjusts the overall volume level.
Provides bass and treble boost at low volumes.
Adjusts volume balance between left and right channels.
Guides centering stereo sound image.
Reduces high-frequency noise from records or broadcasts.
Reduces low-frequency rumble from vibrations or old records.
Enhances mid-range frequencies for clearer speech or instruments.
Reduces high-frequency noise from records or broadcasts.
Reduces low-frequency rumble from vibrations or old records.
Enhances mid-range frequencies for clearer speech or instruments.
Power output ratings for music and continuous sine wave.
Sensitivity and impedance for various input types.
Cutoff frequencies and roll-off rates for filters.
Measures signal-to-noise ratio for various inputs.
Details of tone control range and calibration.
Power draw at no-load and full-load conditions.
Details fuse ratings for different voltages.
Specifies frequency response range with LINEAR engaged.
Measures signal isolation between left and right channels.
Lists transistors, diodes, and ICs used in the amplifier.
To Next Page