• You will always need to put the large bowl in place
first, no matter what you intend to do. Hold the
large bowl with the handle pointing to the right
(3 o’clock), position it onto the bowl drive and
turn it clockwise by 90° (6 o’clock) until you hear
and feel it lock in place
• If you want to use the medium bowl, insert this into
the large bowl; it will self-locate
• If using the small bowl, you will also need to use the
medium bowl & drive shaft. These must be put onto
the bowl drive before the small bowl is inserted
• The small bowl fits into the medium bowl. When
inserting it into the bowl you will need to rotate the
small bowl until the tabs on the medium bowl locate
in the slots on the small bowl (See diagram on
page 14)
• Always try and start with the tasks that require the
smallest bowl first, so that you are removing the
used bowls instead of putting clean bowls inside
dirty ones
THE LARGE BOWL CAN BE REMOVED FROM THE
MAIN BODY WITH OR WITHOUT THE LID LOCKED
IN PLACE.
• Rotate the control switch to the ‘Off’ position
• Unlock the lid prior to removing the large bowl
• Hold the large bowl with the handle pointing to the
right (6 o’clock), turn it anti-clockwise by 90°
(3 o’clock) until you hear and feel it unlock.
13
ASSEMBLING AND USING YOUR PROCESSOR
ASSEMBLING BOWLS
RRoottaattee tthhee bboowwll
aannttii--cclloocckkwwiissee
ttoo uunnlloocckk ffrroomm
tthhee mmaaiinn bbooddyy
REMOVING BOWLS
To Next Page
Loading...
