Dualit Studio User Manual

1
2
WATER FILTER
SURE POUR
™
SPOUT
VIEWING WINDOW
MAX MARK INDICATOR
LID SEAL
HINGED LID
LID LATCH
HANDLE
KNOW YOUR STUDIO KETTLE
1
1
Place the kettle as close to the wall
socket as possible. When in use ensure
the kettle is not placed under kitchen
cabinets. DO NOT STORE OR
USE YOUR KETTLE IN AN
APPLIANCE GARAGE OR
UNDER CUPBOARDS.
BEFORE FIRST USE: FILL TO THE MAX MARKER, BOIL AND THEN DISCARD WATER. REPEAT THIS PROCESS TWICE.
Use the shortest cord possible.
Wrap excess cord round the
cord tidy on the base of
the kettle.
Do not operate on an inclined
plane.
Do not operate in a tray.
POSITION
SETTING UP
All illustrations are for representation only, your model may vary from illustrations shown.
3 4
3
INCLINED PLANE NOT IN A TRAY
2
2
CORD TIDY
In the interest of improving products, Dualit Ltd. reserves the right to change the product specication without prior notice.
FILLING YOUR KETTLE
Ensure the kettle is unplugged. Remove the
kettle from the power base. Gently slide the
lid latch back to open the hinded lid.
WARNING: IF THE KETTLE HAS JUST BOILED, IT WILL BE FULL OF STEAM, WHICH WILL ESCAPE AS SOON AS
THE LID IS OPENED.
Fill the kettle through the hinged lid opening.
Use at least one cup of water (250ml). The water
level must stay below the ‘max’ mark. Save
energy, only boil what you require. Keep kettle
upright and level at all times when lling. Do not
tilt kettle backwards. DO NOT OVERFILL
OR FILL THROUGH THE SPOUT.
Push the hinged lid down to close using the
textured surface. Do not push down on the
lid latch.
WARNING: IF THE KETTLE HAS
JUST BOILED, THE LID WILL BE
HOT.
OPEN
HINGED LID
CLOSE HINGED LID
BOILING WATER
1
Plug the kettle into the power socket. Press
the ‘On/Off’ switch down. The power light will
illuminate and the kettle will start to heat up.
If the kettle is accidentally switched on with no
water inside, the boil-dry device will switch off the
heating element to prevent damage to the kettle.
The kettle will automatically turn off after the
water has boiled.
To turn off before the water has boiled lift the
‘On/Off’ switch up.
Always unplug the kettle after each use.
Remove kettle from the power base.
To avoid the risk of splashing, once the kettle
has boiled wait 10 seconds then pour slowly.
Do not over-tilt the kettle.
TURN ON
3
POURING
2
TURN OFF
CLEANING & CARE
1 3
Unplug and let the kettle cool down
completely before cleaning. Remove the
kettle from the power base.
Wipe the outside and inside surfaces of the
kettle with a soft, damp cloth.
Pinch the water lter tab and pull out of
the kettle spout. Rinse under a tap while
carefully brushing it with a soft brush. Rinse
the kettle out with fresh water. DO NOT
OPERATE KETTLE UNLESS THE
WATER FILTER IS CORRECTLY IN
POSITION.
To insert the water lter back into place, run
the base of the water lter along the inside
of the spout and push down rmly. You
will hear the water lter positively click into
position.
Use descaling products suitable for kitchen appliances, these are readily available online or from most supermarkets or department stores. Use as
per instructions on the packet.
Follow these few simple steps to minimise scale build up in your kettle: Empty the kettle after each use; do not allow water to stand in the kettle
overnight. Use ltered water instead of tap water. Descale the kettle regularly, at least once a month. If you live in a hard water area you may
need to descale more often. When descaling has nished, empty the kettle and rinse it out a minimum of 3 times with fresh water, then rell
with fresh water, boil, then discard boiled water. FAILURE TO DO SO CAN CAUSE INJURY. DO NOT BOIL KETTLE WITH
DESCALING SOLUTION IN IT.
THE BODY
2
REMOVE WATER FILTER INSERT WATER FILTER
DESCALE REGULARLY
U
N
P
L
U
G
W
H
E
N
N
O
T
I
N
U
S
E
P
L
U
G
I
N
B
E
F
O
R
E
U
S
E
U
N
P
L
U
G
W
H
E
N
N
O
T
I
N
U
S
E
P
L
U
G
I
N
B
E
F
O
R
E
U
S
E
U
N
P
L
U
G
W
H
E
N
N
O
T
I
N
U
S
E
P
L
U
G
I
N
B
E
F
O
R
E
U
S
E
INSTRUCTIONS ON ENVIRONMENT PROTECTION
Do not dispose of this product in the usual household garbage at the end of its life cycle. Please hand
it over to a collection point for the recycling of electrical and electronic appliances. The symbol on the
product, the instruction of use or the packaging will inform you about the methods of disposal. The
materials are recyclable as mentioned on its marking. By recycling, material recycling or other forms of
re-utilization of old appliances you are making an important contribution to protect our environment.
Please inquire at the community administration for the authorised disposal location.
FILLING
POWER LIGHT
ON/OFF SWITCH
POWER CORD
POWER BASE
CORD TIDY
POWER CONNECTOR

Dualit Studio Specifications

General

Brand	Dualit
Model	Studio
Category	Kettle
Language	English