The LED remote control is infrared.Please aim at
the bottom of the right LED bar.
Turn on the throttle power, and make sure the LED lamp
LED Lamp button
button on the left side of the deck is on.
W/WW
Flash
Jump
Jump
IC Set
CS
C3
C7
Auto
C16
Pow
er but
ton
Brightness&Light speed
Whole white lamp
&Number of lamp beads
control block
Light change mode
slection block
Multicolor light mode
selection block
Brightness&Light speed
&Number of lamp beads
control block:
Multicolor light mode selection block:
When single color light or whole white light is on, brighter/ darker; when the multicolor light is on, the light
runs faster/ the light runs slower. When you press”IC Set” button, you can choose how many lamp beads work.
Press “IC Set” button again to end the setting.
Tip
“C3”, 3 colors of light shine together;“C7”, 7 colors of light shine together;“C16”, 16 colors of light shine together;
“CS”, single color light shines.
Remote receiver
The lights will only be
controlled
when you oprate
the remote
towards this place
7) Self-diagnosis through dashboard
88
98
%
00 : 0088888
Km/h
VOL
TRIP ODO DST TIME CHA
SET RPM OFF
PAS
Mp/h
8
[ M ]
⑥
⑦
⑨
①②③④ ⑤
⑧
②
④
⑤
⑥
⑦ ⑨
⑧
Fault type Diagnosis Solution
System error
* If the error information
appears, immediately stop
using the product and take
the scooter to the service
center before use. Excessive
use can result in damage
to the product and safety
accidents.
Motor error
Accelerator error
Controller error
None
* The number is displayed when the cruise function is executed at a
constant speed.
* The number is displayed when the brake lever is operated. (When
the indicator lights, the accelerator does n
ot operate.)
①
To Next Page
Loading...
