Front and rear dual suspensions designed by Minimotors. The suspention has two important parts,
the spring and the rubber ,which have a combined funtion to make the performance perfect.
The suspension is easy to remove and assemble with a rubber hammer.
M8 screws
Rubber
hamber
Step1. Loosen the screws
Step3. Take the old suspension out and replace
Step2. Knock suspension cap
Please use an M8 wrench to loosen the screws.
This screw is used to fix the suspension. After
changing suspension,you must tighten it agian
or the suspension will get out and you will fallen
down.
Turn the suspension cap up ,take the old or
broken suspension out and replace the new
one.
Hit the suspension cap with a rubber hamber.
Step4. Knock the suspension cap back
Knock the suspension cap back with a rubber
hamber. Please knock the good
place as the
picture or you will damage the new suspension.
<Don’t forget to tighten the M8 screw back>.
Suspension cap
Positioning module
NO NEED TO WORRY ABOUT OVER KNOCK
This is the positioning module,it is used to prevent
over knocking the suspension and keep the good
place for suspension cap.
To Next Page
Loading...
