EasyManua.ls Logo

Dukane iQ Series LS User Manual

Dukane iQ Series LS
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ISO 9001:2008
Products are manufactured in ISO
registered facilities.
Intelligent Assembly Solutions
www.dukane.com/us
Dukane Part No. 403-574-01
Series
ULTRASONIC GENERATOR/POWER SUPPLY
LS
Users Manual
Dukane Intelligent Assembly Solutions • 2900 Dukane Drive • St. Charles, Illinois 60174 USA • TEL (630) 797- 4900 • FAX (630) 797- 4949
AUTOMATED HAND PROBE PRESS

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Dukane iQ Series LS and is the answer not in the manual?

Dukane iQ Series LS Specifications

General IconGeneral
Input Voltage100-240 VAC
Input Frequency50/60 Hz
Storage Temperature-20°C to 70°C
Operating Temperature0°C to 40°C
ProtectionOver Voltage Protection (OVP), Short Circuit Protection (SCP)

Summary

Section 1 Introduction

Key Generator Features

Highlights of the generator's advanced features like programming, PWM, soft-start, and auto-tuning.

Section 2 Health and Safety

General Considerations

Recommendations for safe, efficient, and injury-free operation, including proper installation and modifications.

Electrical Safety

Guidelines for proper grounding and electrical connections to ensure safe operation.

Section 3 Installation

Before Installation

Key considerations before installing the generator, including lockout/tagout procedures.

RFI Grounding

Proper grounding techniques to minimize electrical noise and ensure system integrity.

Connecting Cables

Steps for connecting probes, power cords, and automation control cables for system operation.

Section 4 Standard Connections

System I/O Panel and Connections

Explanation of system input and output connectors, pinouts, and signal descriptions.

Section 5 Standard System Status and Controls

Section 6 Process Control Settings

Section 7 System Operational Testing

System Verification Tests

Procedures for testing generator operation, including mode key tests and output verification.

System Test

Steps to test the system's ultrasound operation with a connected probe.

Section 8 Troubleshooting

No Ultrasonic Output

Troubleshooting steps for issues related to probe, cables, generator, and operate input.

System Power Output Level Faults

Diagnosis and solutions for overload, over-temperature, and other fault conditions indicated by red output level.

Welding Problems

Common welding issues like weak welds, excess flash, and inconsistent welds, with suggested remedies.

Section 10 Options

Related product manuals