Duke E SERIES - MAINTENANCE INSTRUCTIONS; General Component Adjustments; Door Adjustment Procedure; Door Switch Adjustment

Service Manual for Electric Convection Oven
20
KX THERMOSTAT
WARNING: DISCONNECT OVEN FROM POWER
SOURCE BEFORE PERFORMING
ANY SERVICE.
The KX (Back up)Thermostat is used on the 59-E3C
and 59-E3P Ovens as an Oven Backup Thermostat.
This Thermostat is located behind the right access
panel, next to the Motor. The Thermostat Probe is
located inside the oven parallel to the Oven Door on
the top of the open cavity.
Thermostat
Probe
Thermostat
Probe
Oven
Sidewall
Bracket
NOTE: When removing the KX Thermostat be careful
not to bend the capillary tube at a sharp angle
to prevent kinking.
1. Open Oven Door and carefully remove Thermostat
Probe from upper right front of the Oven.
2. Pull Thermostat Probe through the oven sidewall.
3. Remove two screws then remove side access
panel.
4. Remove two screws and remove mounting bracket.
Backup
Toggle Switch
Mounting
Bracket
Temperature
Plate
Thermostat
Probe
Side
Access
Panel
Knob
Screw
Thermostat
5. Tag and disconnect wires from KX Thermostat.
6. Remove knob from KX Thermostat.
7. Remove nut securing KX Thermostat,
8. Pull KX Thermostat off mounting bracket.
9. Reverse procedure to install a new KX Thermostat.
Be sure berglass insulation is on capillary tube to
Temperature Probe.
BACKUP TOGGLE SWITCH
WARNING: DISCONNECT OVEN FROM POWER
SOURCE BEFORE PERFORMING
ANY SERVICE.
1. Remove two screws then remove side access
panel.
2. Remove two screws and remove mounting bracket.
3. Tag and disconnect wires to Backup Toggle Switch.
4. Remove nut securing Backup Toggle Switch.
5. Pull Backup Toggle Switch off mounting bracket.
6. Reverse procedure to install a new Backup Toggle
Switch.