21
Service Manual for Electric Convection Oven
ELEMENTS
The Elements are attached inside of the oven on the
right side in the following models:
5/9 Series Oven 59-E3C Oven
5/9 The Oven 59-E3P Oven
The Elements are attached inside the oven on the back
in the following models.
6/13 The Oven “E” Series Oven
For both the side and back mounted locations, the
Elements consists of an inner Element, a center Element
and an outer Element. When replacing Elements be
sure to use the correct Element.
Side Mounted Elements
WARNING: DISCONNECT OVEN FROM POWER
SOURCE BEFORE PERFORMING
ANY SERVICE.
1. Inside oven, remove shelves and racks.
2. Remove four screws securing right side panel inside
oven and remove panel. This allows access to the
Blower and the Elements.
Screws
Rack
Shelf
Right
Inside
Panel
Screws
3. Remove right side panel as described in RIGHT
SIDE PANEL REMOVAL to gain access to the
Element connections.
4. Remove screws securing cover over heater wire
terminals on right side of oven.
5. Tag and disconnect Element wires at the terminals.
Disconnect
wires
Disconnect
wires
6. Remove the four screws securing the terminal plate.
7. Open Oven Door.
Brackets
Inner
Element
Center
Element
Outer
Element
8. Remove the two brackets securing the Elements
around the Blower.
9. Slide Element out through inside of oven.
10. Reverse procedure to install an Element.
NOTE: Element lead wires should be torqued to
30 inch pounds.
To Next Page
Loading...
