Duke E SERIES - Back Mounted Elements

Service Manual for Electric Convection Oven
22
Back Mounted Elements
WARNING: DISCONNECT OVEN FROM POWER
SOURCE BEFORE PERFORMING
ANY SERVICE.
1. Inside oven, remove shelves and racks.
2. Remove four screws securing Back Panel inside
oven and remove panel. This allows access to the
Blower and the Elements.
Rack
Back
Panel
Light
Bulb
Panel
ShelfFan
3. Remove screws securing cover over heater wire
terminals on back of oven on the upper left.
4. Tag and disconnect Element wires at the terminals.
Fan
Terminals
Outside back panel
5. Open oven door.
6. Remove the four screws securing the terminal plate
to the oven interior.
Inside back panel
Bracket
Screws
Terminal Plate
Inner
Element
Center
Element
Outer
Element
Bracket
7. Remove the two clamps securing the Elements
around the Blower.
8. Slide Element assembly out through inside of oven.
9. Reverse procedure to install Elements.
NOTE: Element lead wires should be torqued to 30
inch pounds.